Installation [12/2019 - ]: Procedure

1. Insert the stop light switch assembly until the threaded sleeve hits the pedal as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Stop Light Switch Mounting Adjuster
   	Insert in this Direction

   NOTE:

   When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

2. Turn the stop light switch assembly 1/4 turn clockwise as shown in the illustration to install it.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protrusion of the Plunger
   	Turn in this Direction

   Torque: 1.5 N.m (15 kgf/cm, 13 in.lbf) 

   or less

3. Connect the connector.
4. Check the protrusion of the plunger.
   PROTRUSION OF THE PLUNGER
   
   

   Area	Measurement
   a	0.5 to 2.6 mm (0.0197 to 0.102 in.)

5. If the protrusion is not as specified, recheck the stop light switch assembly installation and perform brake pedal adjustment if necessary.

   for Gasoline Model:

   Refer to ADJUSTMENT [12/2019 - 10/2022] , or refer to ADJUSTMENT [10/2022 - ]

   for HV Model:

   Refer to ADJUSTMENT [12/2019 - 10/2022] , or refer to ADJUSTMENT [10/2022 - ]

   NOTE:

   Do not depress or support the brake pedal.

Refer to PROCEDURE - Step 29 [12/2019 - 10/2022] , or refer to PROCEDURE - Step 28 [10/2022 - ]

Refer to PROCEDURE - Step 51 [12/2019 - 10/2022] , or refer to PROCEDURE - Step 49 [10/2022 - ]

Refer to PROCEDURE - Step 52 [12/2019 - 10/2022] , or refer to PROCEDURE - Step 50 [10/2022 - ]